A simple pirate hat

Sprog gets invited to a lot of pirate parties, previously I have made him a cardboard tube sword and scabbard, and a pirate vest. I have been talking about using the pleather scraps from the vest to make a hat for a while, so the time had arrived.

It was a very simple sew. I took a large square of pleather and folded it wrong sides together. Then I tucked the fold in on itself. You could also get this effect by folding right sides together, then folding back over the fold leaving an inch or so of the original fold in place.  I sewed perpendicular to the fold at each end.

Next I cut an approximate pirate shape to the fabric and stitched around the edge. Pleather is hard to sew on my machine when the right sides are out, as it sticks against the foot. To combat this I used masking tape down the line where I wanted to sew, sewed the line, then peeled the tape away.

Next up I cut a slit in the original fold, and tested it on Sprog's head. I repeated this till it was nearly right, then rounded off the ends of the slit. The rounding off was to make it less likely to tear, and to make it prettier.

This morning shortly before the party Sprog cried "Mummy, you gotfor the bones" (His own take on forgot). Indeed I had, or rather I wasn't going to bother until he said something. Ideally I should have put the "bones" on before sewing it up, but since I was making it up as I went along that was risky business. 

For the bones I cut a skull, lower jaw and femur bones out of the pleather which conveniently has a white backing. I also had white knit scraps I could have used, but the pleather is stiffer and will hold shape better, and the two "leather" sides stick together well making them easy to keep in place while sewing. I tacked them in place using a needle and thread, big stitches as I was in a hurry and the hat was done.

Here's my happy little pirate.

Next pirate party it will likely be the turn of the flowy pirate shirt, or the pirate trousers.